CorelDRAW lets you rotate and create
mirror images of objects. You can rotate an object by specifying horizontal and
vertical coordinates. You can move the center of rotation to a specific ruler
coordinate or to a point that is relative to the current position of the object.
Rotating objects around a single point
Mirroring an object flips it from left to right or top to bottom. By default,
the mirror anchor point is in the center of the object.
In the Transformations
docker, click one of the following:
lets you flip the object from left to right
lets you flip the object from top to bottom
If you want to flip the object on
a specific anchor point, enable the check box that corresponds to the anchor
point you want to set.
You can also mirror a selected object
by holding down Ctrl and dragging a selection handle to the opposite side of the
You can open the Transformations docker by clicking Arrange Transformations and
selecting an option from the flyout.
Copyright 2000-2005 Corel Corporation. All rights